Product ID:ELMER'S CLEAR SILICONE RUBBER SEALER, E920
MSDS Date:04/01/1992
FSC:8030
NIIN:00N088097
MSDS Number: CHNWW

BORDEN INC

180 E BROAD ST
COLUMBUS, OH 43215
US

Emergency Phone: 614-431-6600

Info Phone: 614-431-6680

Cage: 07982

BORDEN INC

208 COLUMBUS, OH 43215-3705 US

Telephone: 614-225-6124

Cage: 07982

SILICA

CAS: 112945-52-5

RTECS: VV7310000

Fraction By Weight: 10-30%

OSHA PEL 6 MG/M3

ACGIH TLV: 10 MG/M3

ETHYLTRIACETOXYSILANE

CAS: 17689-77-9

Fraction By Weight: 1-5%

OSHA PEL N/K

ACGIH TLV: N/K

ISOLATION & REMOTE CONTROL IN COMBINATION W/APPROP

RTECS: 9999999ZZ

THESE TECHNIQUES MAY NOT NECESSARILY ADDRESS ALL

RTECS: 9999999ZZ

RECOMMENDS THAT YOU CONSULT W/EXPERTS OF YOUR CHOICE

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:SKIN ABSORPTION: NOT TOXIC DERMALLY
WHEN TESTED AS DESCRIBED IN 16 CFR 1500.3 (C)(1) & (2). INGEST: NOT
TOXIC ORALLY WHEN TESTED AS DESCRIBED IN 16 CFR 1500.3 (C)(1) &
(2). INHAL: NOT EXPECTED TO BE H ARMFUL UNDER NORM CNDTNS OF USE.
HOWEVER, IF ALLOWED TO BECOME AIRBORNE, MAY CAUSE IRRIT OF NOSE,
(EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ: THROAT & LUNGS. NOT TOX BY INHAL WHEN
TESTED AS DESCRIBED IN 16 CFR 1500.3 (C)(1) & (2). SKIN: MAY CAUSE
IRRIT ON PRLNGD/RPTD CNTCT. NOT PRIMARY IRRITANT (PRIMARY SKIN
IRRIT INDEX <5.0/8.0) WHEN TESTED AS DESCRIBED IN 16 CFR 1500.41.
EYE: CAUSES IRRIT. MOD IRRIT WHEN TESTED AS DESCRIBED IN 16 CFR
(SUPDAT)
Medical Cond Aggravated by Exposure:PRE-EXISTING RESPIRATORY DISORDERS
MAY BE AGGRAVATED BY EXPOSURE TO SILICA.

First Aid:INGEST: IF ACCIDENTALLY SWALLOWED, DILUTE BY DRINKING LARGE
QTYS OF WATER. IMMED CNTCT POIS CTL CTR OR HOSPITAL EMER ROOM FOR
ANY OTHER ADDNL TREATMENT DIRECTIONS. INHAL: REMOVE TO FRESH AIR.
SKIN: IN CASE OF IRRIT, FLUSH W/WATER. EYES:IMMED FLUSH EYES
W/PLENTY OF WATER FOR AT LEAST 15 MIN. EYELIDS SHOULD BE HELD APART
DURING IRRIGATION TO INSURE WATER CNTCT W/ENTIRE SURF OF EYES &
LIDS. CALL MD.

Flash Point:212F,100C
Extinguishing Media:IN CASE OF FIRE, USE WATER SPRAY, DRY CHEMICAL,
FOAM OR CARBON DIOXIDE.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA AND FULL PROTECTIVE
EQUIPMENT . USE WATER TO KEEP FIRE-EXPOSED CONTAINERS COOL.
Unusual Fire/Explosion Hazard:WILL BURN.

Spill Release Procedures:SWEEP (SCOOP) UP AND REMOVE TO A CHEMICAL
DISPOSAL AREA. PREVENT ENTRY INTO NATURAL BODIES OF WATER.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE IN COOL, DRY PLACE. KEEP CNTNRS
TIGHTLY CLOSED. EXPOSURE TO SMALL AMTS OF MOISTURE, EVEN MOISTURE
IN AIR, CAUSES POLYM & RENDERS PROD UNUSABLE.
Other Precautions:AVOID PROLONGED OR REPEATED BREATHING OF VAPOR. AVOID
PROLONGED OR REPEATED CONTACT WITH SKIN. AVOID CONTACT WITH EYES.
WASH THOROUGHLY AFTER HANDLING.

Respiratory Protection:NO SPECIAL PROTECTION NECESSARY. USE NIOSH
APPROVED RESPIRATOR APPROPRIATE FOR EXPOSURE OF CONCERN .
Ventilation:IF AIRBORNE CONTAMINANTS ARE GENERATED WHEN MATL IS HEATED
OR HANDLED, SUFFICIENT VENT IN VOLUME & AIR FLOW (SUPDAT)
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPROVED EYE WASH & DELUGE SHOWER .
Work Hygienic Practices:HANDLE I/A/W GOOD INDUS HYGIENE & SFTY PRACTS;
INCLUDES AVOIDING UNNEC EXPOS & REMOVAL OF MATL FROM EYES, SKIN &
CLTHG.
Supplemental Safety and Health
PH: 1.04 @ 25C. EFTS OF OVEREXP: 1500.42. SILICA CAN CAUSE LUNG
FIBROSIS. VENT: PATTERNS SHOULD BE PROVIDED TO KEEP AIR CONTAMINANT
CONC LEVELS BELOW ACCEPTABLE CRITERIA. FOLLOWING EXPOS CONTROL
TECHN IQUES MAY BE USED TO EFFECTIVELY MINIMIZE EMPLOYEE EXPOS:
LOCAL EXHAUST VENT, ENCLOSED SYSTEM DESIGN, PROCESS (ING 3)

Vapor Pres:<5 @ 20C
Spec Gravity:1.04
pH:SUPDAT
Solubility in Water:NEGLIGIBLE
Appearance and Odor:OPAQUE PASTE; ACETIC ACID ODOR.
Percent Volatiles by Volume:<5

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS.
Stability Condition to Avoid:NORMALLY STABLE AS DEFINED IN NFPA 704-12
(4-3.1).
Hazardous Decomposition Products:LIBERATES ACETIC ACID ON CURING.
DECOMPOSITION PRODUCTS MAY INCLUDE OXIDES OF CARBON AND SILICON.

Waste Disposal Methods:DISPOSE OF ACCORDING TO LOCAL, STATE/PROVINCIAL
AND FEDERAL REQUIREMENTS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.